Entering Fireground Zone Channel - Motorola APX 7000 User Manual

The Fireground signals transmission is always exchanging data
between your radio and the RF Modem and command terminal.
The status of your radio includes
•
Powering up or down the radio
•
Automatic response to Polling
•
Response to Evacuation commands
•
Pressing the PTT button to make voice transmission
•
Sending an Emergency Alarm and Call


Entering Fireground Zone Channel

Procedure:
1
Upon Powering Up
If the Fireground Zone Channel is set as default, you hear
gurgle tone and the home screen. You are in Fireground
zone channel.
OR
If the Fireground Zone Channel is set as default, but you
hear a short, low-pitched tone, the display shows Reg
failed to indicate that the command terminal does not
respond to Fireground Zone Channel. Get qualified
technician for assistance.
OR
Your home channel is not Fireground Zone Channel, toggle
or change the radio zone channel to Fireground Zone
Channel.
70
English
2
Listen for a transmission. Adjust the Volume Control Knob if
necessary.
3
Press and hold the preprogrammed Volume Set button to
hear the volume set tone. Adjust the Volume Control knob if
necessary. Release the Volume Set button.
OR
At the desired Fireground zone and channel, press the
preprogrammed Monitor button and listen for activity. Adjust
the Volume Control knob if necessary.
OR
If your radio is working in Fireground Zone Channel,
proceed to next step.
4
Press and hold the PTT button to transmit. The LED lights
up solid RED while transmitting. Talk into the microphone
clearly if needed.
5
Release the PTT button to receive. You hear a Transmit End
Tone.