Download Print this page

Nokia 9460 S Owner's Manual

Satellite receiver.
Hide thumbs


Owner's Manual
9460 S


   Related Manuals for Nokia 9460 S

   Summary of Contents for Nokia 9460 S

  • Page 1

    Owner’s Manual MEDIAMASTER 9460 S...

  • Page 3: Quick Guide

    Quick guide Satellite dish The satellite dish must have a clear view to the satellites. Mount the satellite dish according to the fitting instructions. In case you already have a satellite dish mounted, note that you need a Universal LNB which works on the frequencies 10.70- 12.75 GHz to be able to handle digital signals.

  • Page 4: Quick Guide

    Quick guide One antenna/one LNB configuration Select this alternative if you have one (1) LNB mounted on the antenna. • Press opt to view the predefined channel. LNB type Select the correct LNB type for your configuration. The most common values, including Universal LNB, are selectable with the cursor left and cursor right but- tons.

  • Page 5: Table Of Contents

    Nokia operates a policy of continuous development. Therefore we reserve the right to make changes and improvements to any of the products described in this manual without any prior notice.

  • Page 6

    GB 6...

  • Page 7: General Information

    • Do not allow the unit to be exposed to hot, cold or humid conditions. • Service should be carried out only at a Nokia Authorised Service Centre. • Please note that the only way to isolate the Mediamaster completely from...

  • Page 8: Remote Control

    REMOTE CONTROL This section describes how to operate the Mediamaster using the buttons on the remote control. The standby button has double functions. One function is carried out if you press the button gently once and the other function is carried out if you hold down the button for a few seconds. Some of the functions can also be carried out using the buttons on the front panel.

  • Page 9: Front And Rear Panel

    FRONT AND REAR PANEL Front panel to put the Mediamaster in and out of standby mode LED 1 to change channels LED 2 Function LED indicator 1 LED indicator 2 Green Standby Locked to channel Green (locked) / Red (not locked) Remote control feedback Single flash SW download...

  • Page 10: Preparing The Remote Control

    INSTALLATION OF THE MEDIAMASTER The box for your Mediamaster should contain the following items: • the Mediamaster • remote control with 2 AAA batteries • SCART cable (fully featured 1.0 metre) Owner’s • mains cable manual • owner’s manual with software license agreement SCART cable Mains cable About the SCART sockets...

  • Page 11: Connecting A Tv And Vcr

    • Connect the TV aerial to the RF input socket on the analogue receiver. In order to switch the signal from the dish between the analogue and digital Mediamaster receivers, you need a Nokia smart switch (at A B in the diagram) or a Universal Twin LNB. Analogue receiver Nokia smart switch •...

  • Page 12: First Time Installation

    FIRST TIME INSTALLATION General information Once you have correctly connected the Mediamaster, you also have to perform a “First time installation.” During this procedure, helpful information is displayed at the bottom of the menus. Please note! The select button always confirms a selection within these menus, and pressing it will take you to the next step in the installation process.

  • Page 13: One Antenna/one Lnb Configuration

    FIRST TIME INSTALLATION One antenna/one LNB configuration Select this alternative if you have one (1) LNB mounted on the antenna. • Press opt to view the predefined channel. LNB type Select the correct LNB for your configuration. The most common values, includ- ing Universal LNB, are selectable with cursor left/cursor right.

  • Page 14: Motor Antenna Configuration

    • From the “Antenna/Satellite selection” menu select alternative 3 “Motor An- tenna Configuration” and press select. Type of motor • Select SATSCAN (Astra) if it is a Nokia SatScan motor. • Select DiSEqC (Hotbird) in case the motor you use is controlled by DiSEqC com- mands.

  • Page 15: Channel Search

    FIRST TIME INSTALLATION Adjust motor for ASTRA/HOTBIRD To continue the installation you now have to determine the angle to ASTRA 1/HOTBIRD. The motor and the antenna must be adjusted to- wards the ASTRA 1 satellites on 19.2 East (HOTBIRD satellites on 13 East) as this is the reference setting.

  • Page 16: Channel Search Progress

    FIRST TIME INSTALLATION Adjust motor: This alternative will only be visible if you have made a motor antenna configuration. Adjust (if necessary) the motor for the current satellite. • Press select to start searching for channels. Advanced manual search The information you need to enter in this menu is available in magazines covering satellite TV reception or on the Internet.

  • Page 17: Navi™ Bars Navigator

    NAVI™ BARS NAVIGATOR Bookmark General information Bookmark name • Press select to open the Navi™ Bars Navigator. In order to select TV/Radio channels and to change system settings you will use the Navi™ Bars Navigator. In this manual the name is shortened to Navigator. The horizontal row contains folders, e.

  • Page 18: The "control" And The "settings" Folder

    NAVI™ BARS NAVIGATOR The “Control” and the “Settings” folders Both of these system folders contains a few bookmarks. Each of these bookmarks contains menus from where you can make different settings. The system folders can not be deleted. The manual will now explain the different settings you can perform from the Con- trol and Settings folders, starting with the bookmarks from the Control folder.

  • Page 19: Edit Channels

    NAVI™ BARS NAVIGATOR Control Edit channels From these menus you can create and edit favourite channel lists. You can add, delete, rename and arrange the order of the channels within the favourite lists. The “All TV”or “All Radio” lists might contain lots of channels. By creating your own favourite lists you can make channel handling a bit more convenient.

  • Page 20

    NAVI™ BARS NAVIGATOR Delete list If you want to delete a Favourite list, select the list with cursor left/cursor right and press select. Rename list You can give an existing list a new name by following the instructions under the headline “How to give a specific name”...

  • Page 21: Edit Satellites

    NAVI™ BARS NAVIGATOR Control Edit satellites You can add a new satellite to the system. You can also edit or delete existing sat- ellites. To add a new satellite • Select “Add Satellite”. • Enter the name of the new satellite. (How to enter a name is described on page 19.) •...

  • Page 22: Timer

    15. Update channels via a PC On the Nokia web site ( you can download a Windows™ software for updating the channel lists via the serial port. The serial port connector can be found on the back of the Mediamaster (See page 9) .

  • Page 23: Access Ctrl

    From here you can change the access code from the standard 1234. DO NOT FORGET IT! Without it you do not have access to any of the functions where the code is required! If you forget it, you have to contact an Authorised Nokia Service Centre to get help. GB 23...

  • Page 24: Time

    In order to keep the Mediamaster up-to-date, it will be possible to download new versions of the system software via satellite or with a Windows™ software pro- vided by Nokia. From this menu you can only download new software via satellite. New software may include new or improved features for existing menus.

  • Page 25: Viewing Mode

    VIEWING MODE General information The following describes the basic functions of your Mediamaster while watching satellite TV or listening to satellite radio. Some of the functions described here are dependent on the Service Provider and can only be used if they are included in the transmitted programme in- formation.

  • Page 26: Temporary Settings

    VIEWING MODE Temporary settings By pressing opt you open a menu in which it is possible to enter temporary set- tings. Settings made in this “options menu” are only valid for the channel you cur- rently are watching. If you leave the channel and return to it again, the temporary settings will be gone.

  • Page 27: Glossary

    GLOSSARY OF TERMS AC-3 Multichannel digital audio encoding system. Pulse Code Modulation. Non-compressed digital audio format. Access control A feature that allows parents to ”lock” programmes that they con- Program Clock Reference. sider unsuitable for children. A ”locked” channel or programme can only be ”unlocked”...

  • Page 28: Problem Solving

    PROBLEM SOLVING Problem Possible causes What to do The LED on the front panel does not light Mains cable is not connected. Check that the mains cable is plugged into up/is not lit. the power socket. The left LED is shining red The Mediamaster is in standby mode.

  • Page 29: Technical Specifications

    TECHNICAL SPECIFICATIONS Transmission standards Front panel DVB, MPEG 2 2 LEDs, Buttons: (standby, progr. number up and down) LNB / Tuner input Other data Connector 1x F-type (LNB) The model code, variant and serial number, are located on a RF input frequency 950-2150 MHz label on the underside of the housing.

  • Page 30: Menu Screen Structure

    MENUS SCREEN STRUCTURE First time installation Channel Search in Progress Language preferences Antenna/satellite selection Antenna adjustment Channel search “First time English NB type installation” One antenna/One LNB config Deutsch Automatic search CNN Radio LNB offset voltage menu Multisatellite/DiSEQqC Switch config Français Manual search Motor antenna configuration...

  • Page 31

    Navi, Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation © 0218 66 76985-14...

This manual also for:

Mediamaster 9470 s

Comments to this Manuals

Symbols: 0
Latest comments:
  • Vigo Abel Jan 08, 2017 05:54:
    Je n arrive pas a trouvé le code merci