To program the download enable option:
1. Enter the System Programming menu.
2. Scroll until the display shows Security, and then press OK.
3. Scroll until the display shows Download Enable, and then press OK. The
current value of this option flashes on/off.
4. Scroll to the desired value, and then press OK.
5. Press Status repeatedly to exit.
Phone numbers
Phone #4 is the only system phone number that you can change. Therefore, it is often
used for voice reporting alarms to your phone and can be programmed for this
purpose by the installer.
To change Phone #4:
1. Enter the System Programming menu.
2. Scroll until the display shows Phone #s, and then press OK.
3. Scroll until the display shows Phone #4, and then press OK. The first digit of the
current value of this option flashes (this may take up both lines on the display).
4. Change each digit of the phone number by scrolling or entering a numerical
value, and then move to the next digit by pressing OK.
5. When done, press OK again to save the new phone number.
6. Press Status repeatedly to exit.
The phone number can be deleted by pressing Disarm while changing a digit.
Timers
The latchkey time option is the only timer setting available to you. The latchkey time is
the time of day by which the panel must be disarmed to avoid triggering a latchkey
alarm, if the latchkey time option is enabled during arming.
To change the latchkey time:
1. Enter the System Programming menu.
2. Scroll until the display shows Timers, and then press OK.
3. Scroll until the display shows Latchkey Time, and then press OK. The HH
(hours) part of the time flashes.
4. Program the hours value by scrolling or entering a numerical value, and then
press OK. The MM (minutes) part of the time flashes.
24
Simon XT User Manual