Honda XR250R Owner's Manual page 20

Hide thumbs Also See for XR250R:
Table of Contents

Advertisement

1. Turn the adjuster knob counter clockwise
until it will no longer go.
2. Check that the yellow dots (4) on the
knob and reservoir are aligned. If they
are not aligned, turn the knob clockwise
until they are aligned.
3. The adjuster is set in the standard
position when the knob is turned
clockwise 12 positions (3 rotations) from
the above position.
14
Spring preload:
1. Remove the left and right side covers.
2. Remove the seat, exhaust muffler and air
cleaner box.
CAUTION:
Be careful not to allow dust into the
carburettor.
3. Place a support under the engine to raise
the rear wheel off the ground.
4. Measure the spring length (5).
(5) Spring length
(6) Lock nut
(7) Adjusting nut
(A) Increase Preload
(B) Decrease Preload

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents