Advertisement
11. Route the CD changer BUS cable connector from
the center panel opening to the audio unit opening.
AUDIO UNIT
OPENING
CENTER PANEL
OPENING
12. Remove the two washer-screws from the
dashboard at the sides of the center panel
opening.
LEFT
VEHICLE
BRACKET
CD
CHANGER
WASHER-
SCREW
(reused)
SCREW
(reused)
13. Plug the vehicle connector into the rear of the
heater control unit, then slide the heater control
unit and the CD changer into the center panel
opening. Reinstall the two washer-screws through
the DIN bezel, and reinstall the four screws
removed in step 8.
4 of 7
BUS CABLE
CONNECTOR
VEHICLE
CONNECTOR
HEATER
CONTROL UNIT
RIGHT
VEHICLE
BRACKET
WASHER-SCREW
(Reuse.)
14. Remove the left and right audio brackets (two
washer-screws and self-tapping screw for each
bracket). Separate the audio unit and pocket.
Discard the pocket.
WASHER-SCREW
(Reuse.)
LEFT AUDIO
BRACKET
SELF-
TAPPING
SCREW
(Discard.)
15. Install the cassette player/in-dash CD changer.
With Cassette Player:
•
Set the audio unit on the cassette player, and
attach the left and right audio brackets to the
audio unit with the four washer-screws
removed in step 14.
•
Attach the left and right audio bracket to the
cassette player with the four 5 x 8 mm washer-
screws included in the cassette player kit.
Install the screws in the order shown ( 1 and
2 ).
WASHER-
SCREW
(removed in
step 14)
2
1
Insert the bolts
through the lower
holes.
AII 28061 (0409)
RIGHT
AUDIO
AUDIO
UNIT
BRACKET
SELF-TAPPING
SCREW
POCKET
(Discard.)
(Discard.)
5 x 8 mm
WASHER-SCREW
(included with the
cassette player)
AUDIO
UNIT
LEFT
AUDIO
BRACKET
RIGHT
AUDIO
CASSETTE
BRACKET
PLAYER
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
WASHER-
SCREW
(Reuse.)
WASHER-
SCREW
(removed in
step 14)
2
1
5 x 8 mm
WASHER-
SCREW
(included
with the
cassette
player)
Advertisement
