Grizzly Pneumatic Sanding Drum G1970 Operation Manual

Operation
1.
DISCONNECT BUFFER FROM POWER!
2.
Install the sanding drum on the buffer shaft
using the spacers and flanges included with
the buffer (Figure 2).
Figure 2. Mounting drum to shaft.
3.
Slide the sanding sleeve over the sanding
drum.
4.
Use a bicycle pump (or other manual pump)
to inflate the drum until the sanding sleeve is
secure. Do not exceed the 10 PSI maximum
rating.
Operation Tips
• Adjust the pressure in the drum to fine-tune
its firmness for sanding contours.
• Always hold the workpiece firmly—the soft
surface of the drum will exert more force
on the workpiece than a traditional sanding
drum.
• Deflate the drum when not in use.
-2-
G1970/G1971/G1972 Pneumatic Sanding Drum