Connecting The Network Cable - HP NC552SFP User Manual

Using a correctly sized Phillips head screwdriver, carefully remove the two board lock screws located
1.
above and below the SFP+ connectors.
Remove the standard profile bracket and place the low profile bracket over the connectors. Be careful
2.
not to damage the connectors or bend the low profile bracket.
Reinstall the two Phillips screws.
3.

Connecting the network cable

The HP NC552SFP 10GbE 2P Adapter has two SFP+ ports. These ports support either of the following:
•
Direct Attached Copper (DAC) cables
•
Optical Modules to be used with fiber optic cables
See Cable specifications (on page 10) for the maximum cable length supported.
To connect the HP NC552SFP 10GbE 2P Adapter to the network, complete the following steps:
Orient the SFP+ optical module or DAC cable so that the Gold Fingers on the edge of the circuit board
1.
is located closest to the option card circuit board.
Install the SFP+ optical module or DAC cable all the way into the SFP+ socket until it clicks into place
2.
and is securely latched.
If an optical module is used, remove the protective cover and connect the fiber optic cable.
3.
Installing an adapter 9