Download Print this page

Removing A 2.5-Inch Hot-Swap Hard Disk Drive - IBM 6385 User Manual

Types 6385, 6386, 6389, 7831, 7832, and 7834
Hide thumbs


Removing a 2.5-inch hot-swap hard disk drive

Note: The following illustration shows how to remove a 2.5-inch hot-swap hard disk
drive from a 2U chassis.
Note: You do not have to turn off the server to remove a hot-swap drive.
To remove a 2.5-inch hot swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Rotate the drive tray handle to the open position.
3. Grasp the handle; then, pull the drive out of the drive bay.
4. Store the drive for later use.
IBM dx340 User's Guide
on page 23.
Note: A hard disk drive or filler panel must always be installed in each drive
bay when the server is turned on.
Note: If you install or remove a hard disk drive, see the documentation that
comes with your RAID adapter for information about reconfiguring the disk



  Also See for IBM 6385

  Related Manuals for IBM 6385

This manual is also suitable for:

63867831638978347832System x idataplex dx340