Life Fitness x3 Assembly & Operation Manual page 9

1.4 S
ETUP
CONTINUED
6. Insert two (#4) 1 inch bolts and two (#9) washers into
backside of connector joint on base frame. Start each bolt,
and then tighten with a 9/16 socket wrench.
7. Tighten four (#5) 3-inch bolts with a 9/16" socket wrench.
S 3
TEP
Attach Plastic Upright Cap to upright assembly:
1. Push the Plastic Upright Cap into open end of tube at the top of the upright assembly.
2. Line up hole in nose cone with hole in upright assembly and fasten with a (#3) screw.
(#10)
(#3)
Plastic
Upright
Cap
Upright
assembly
9
8. Push the ten (#10) black plastic cover caps
over each bolt head.