Life Fitness x3 Assembly & Operation Manual page 10

1.4 S
ETUP
CONTINUED
S 4
TEP
Attach heart rate accessory tray to upright assembly:
NOTE: This step applies to model x3i only.
1. Before attaching the accessory tray, it is helpful to form the threads in the console plate. Using a 3/8" socket wrench, start
the (#0) self-tapping screws into the holes. When threads have formed, remove the screws.
2. Feed the upper wire harness through the slot in the accessory tray bracket.
3. Line up the holes on the accessory tray bracket with the holes on the console plate, and then secure the accessory tray with
the two (#0) self- tapping screws using a 3/8" socket wrench.
S 5
TEP
Plug cables into back of display console:
1. Plug the 10-pin connector at the end of the upper wire harness into the 10-pin connector in the back of the display console.
Make sure the connector snaps into place.
2. Plug the 3-pin connector at the end of the heart rate cable into the 3-pin connector in the back of the display console. Make
sure the connector snaps into place.
3. Plug in flat 6 pin connector for the Activity Zone.
4. Push access cable(s) into opening of upright assembly.
NOTE: #2 and #3 apply to model x3i only.
#0
Activity Zone
plug-in (6-pin)
10