Connection; Using A Euroblock Connector; Speaker Connection - Yamaha XP7000 Owner's Manual

Connection

■

Using a Euroblock connector

If cables will be frequently connected and disconnected,
as in the case of a portable installation, we recommend
that you use ferrules with insulation sleeves. Use a fer-
rule whose conductor portion has an external diameter of
1.6mm or less, and a length of approximately 7 mm
(such as the AI0,5-6WH made by the Phoenix Contact
corporation).
1 If the wire insertion ports are closed, turn the screws on
top of the connector counterclockwise to open the ports.
2 Insert the wires into the appropriate ports, following the
indication of the pole on the input terminal, turn the
screws on top of the connector clockwise to fix the
wires.
3 Attach the Euroblock connector to the input terminal on
the unit.
■

Speaker Connection

● 5-way binding post
1 Turn off the POWER switch.
2 Remove the cover attachment screws and remove the
protective cover from the speaker terminals.
3 Remove about 15 mm of insulation from the end of each
speaker cable.
Pass the bare wire through the holes in the appropriate
speaker terminals. Tighten the terminals to securely
clamp the wires. Refer to page 8 for speaker polarities.
Speaker
cable
* Actual size
● Speakon connector
1 Turn off the POWER switch.
2 Insert the Neutrik NL4FC plugs into the Speakon con-
nector on the rear of the amplifier, and turn clockwise to
lock.
Neutrik NL4FC plugs
Be sure that the bare wire ends do not jut out from the
terminals and touch the chassis.
Screw
4 Reattach the protective cover over the speaker termi-
nals.
CHANNEL
STEREO or PARALLEL
1+
1–
2+
2–
CHANNEL
1+
1–
XP7000/XP5000/XP3500/XP2500/XP1000 Owner's Manual
+
Chassis
Bare wire
Å
BRIDGE
A+ 1+
A– 1–
B+ 2+
B– 2–
ı
B+
B–
Use a screwdriver
to fix the wires.
G
–
+
–
11