Table of Contents
Advertisement
The operating panel
Stand-by mode
The operating panel (see the illustration on inside back cover) on the Océ
7055/7056 is easy to use and specially designed to carry out copy jobs. After
switching on, (see page 9), the machine is always ready for operation: the
display shows blinking LEDs. In this state, the operating panel is in stand-by
mode. The operating panel activates in the following situations:
you feed an original
you feed a copy material
a button on the operating panel is pressed
a roll unit is opened.
If you do not work with the operating panel for more than 2 minutes, it
Note:
returns automatically to stand-by mode. The Océ 7055/7056, however, remains
always for operation.
Buttons and functions
Start button The copy process starts with the current settings.
Stop button The stop button stops the current copy process immediately
without finishing the current job. The original and the copy material remain in
the copier.
Exposure level You modify the exposure level with the 'lighter' and 'darker'
buttons. The exposure level can be changed at all times.
Copy material input button With this button you choose the input of the copy
material. Possible input selections are manual feed, roll 1 or roll 2.
Copy material selection button If you have selected manual feed, you use this
button to select the copy material. Your selection, paper or film, influences the
fusing temperature. All materials, except for film, should be copied in the
'paper' setting. You also use this button to program the copy material on a roll.
Introduction
7
Hide quick links:
Advertisement
Table of Contents
