Rules For Safe Operation - Axminster Excalibur EX-16 User Manual

To help ensure safe operation, please take a moment to learn the machine's
applications and limitations, as well as potential hazards. Axminster Tool Centre
disclaims any real or implied warranty and holds itself harmless for any injury
that may result from the improper use of its equipment.
1. Be sure to read, understand and follow all safety
warnings and instructions in the supplied Operator's
Manual.
2. Do not operate the saw when tired, distracted, or
under the effects of drugs, alcohol or any medication
that impairs reflexes or alertness. Stay alert! Give your
work your undivided attention.
3. Keep the work area well lit, clean and free of debris.
Cluttered areas and benches invite injuries.
4. Keep children and shop visitors at a safe distance
while operating the saw; do not permit them to operate
the scroll saw.
5. Childproof and tamper proof your shop and all
machinery with locks, master electrical switches and
switch keys, to prevent unauthorized or unsupervised
use. Fine particulate dust is a carcinogen that can be
hazardous to health. Work in a well ventilated area and
use a dust collector whenever possible.
7. Wear approved safety glasses, dust mask and
non-skid footwear. Do not wear loose clothing, gloves,
bracelets, necklaces or jewellery while operating the
saw. Keep long hair contained by wearing protective
hair covering.
8. Be sure all adjustment tools, wrenches or other
clutter are removed from the machine and/or the table
surface before operation. When not in use, tools should
be locked-up in a dry place, out of children's reach and
away from flammable substances.
9. Keep hands well away from saw blade and all
moving parts. Use a brush, not hands, to clear away
chips and sawdust.
10. Be sure that saw blade is properly installed, and in
proper cutting direction, before operation. Always use a
clean, properly sharpened blade. Dirty or dull blades
are unsafe and can lead to accidents. Also, be sure the
blade has gained full operating speed before beginning
to cut.
11. Do not push or force stock into the blade. The saw
will perform better and more safely when working at the
rate for which it was designed. Do not use for purposes
not intended.

Rules for Safe Operation...

12. Avoid working from awkward or off balance
positions. Do not overreach while cutting; keep both
feet on floor. Never lean over or reach behind the blade
and never pull the workpiece through the cut from
behind.
13. Never stand or lean on the saw. Serious injury
could occur if the unit is tipped over or if the blade is
unintentionally contacted.
14. Use of parts and accessories NOT recommended
by Axminster Tool Centre may result in equipment
malfunction or risk of injury.
15. Never leave the machine unattended while
running or with the power "ON".
16. Always turn off and disconnect from power source
before servicing or changing accessories, blades, bits,
and cutters, or before performing any maintenance or
adjustments.
17. Make sure that switch is in the "OFF" position
before plugging in the power cord. Do not use the saw
if the power switch is defected, have defective switches
replaced by an authorized service centre.
18. Make sure saw is properly grounded. If equipped
with a 3-prong plug it should be used with a three-pole
receptacle. Never remove the third prong. Avoid body
contact with grounded surfaces (e.g. pipes, radiators,
stoves, refrigerators).
19. Repairs to the saw should only be carried out by
qualified people using original spare parts. A guard or
other damaged part should be properly repaired or
replaced by an authorized service centre.
20. Inspect power cords and extension wires
periodically. If damaged, have them repaired by an
authorized service facility. Never yank cords and wires
and keep away from heat, oil, and sharp edges.
21. This tool is for indoor use only. Do not expose to
rain or use in wet or damp locations.
FREEPHONE 0800 371822
03