To use the faceplate:
1.
2.
3.
4.
5.
31.
Figure 31.
Use a minimum of three independent clamp-
ing devices when using faceplate. Failure
to provide adequate clamping may cause
workpiece to eject during operation.
6.
7.
Tip: Hand-held tapered bore wipers make this
task very time efficient, and offer consistently
clean bores.
Figure
Figure 32.
Solid Dead Center
33
Tip: If the tail is too large for a slot, install the
3-jaw chuck, open the jaws so the workpiece can
be supported by the center and the tail of the dog
can rest against a jaw.
Figure 33.
Centers
Figure 32
Figure