Switching The Phone On And Off; If The Phone Requests A Pin Code; If The Phone Requests A Security Code - Nokia 6210 User Manual

If the battery is totally flat, it may take a
few minutes before the charging
indication appears on the display or any
calls can be made.
The charging time depends on the
charger and battery used. For example,
charging a BLS-2 battery takes about 4
hours.
3. The battery is fully charged when the
battery indicator bar stops scrolling, and
the text Battery full
the phone is on).
4. Disconnect the charger first from the AC
outlet and then from the phone.
If the text Not charging
charging has been suspended. Wait for a
while, disconnect the charger, plug it in
again and retry. If charging still fails, contact
your dealer.
For more information, see
information" on page
■ Switching the phone on
and off
Press and hold the
10
is briefly displayed (if
is displayed,
"Battery
50.
key for a second.
Copyright © 2004 Nokia. All rights reserved.

If the phone requests a PIN code:

The PIN code is usually supplied with the SIM
card.
• Key in the PIN code (displayed as ****), and
press OK.
See also "Access codes" on page
If the phone requests a security
code:
• Key in the security code (displayed as
*****), and press OK.
See also "Access codes" on page
Warning! Do not switch on the
phone when wireless phone use
is prohibited or when it may
cause interference or danger.
Note: Your phone has a built-in antenna. As
with any other radio-transmitting device, do
not touch the antenna unnecessarily when
the phone is switched on. Contact with the
antenna affects call quality and may cause
the phone to operate at a higher power level
than otherwise needed. Not touching the
antenna during a call optimizes the antenna
performance and the talk-time of your
phone.
G e t t i n g s t a r t e d
50.
50.