Collectors; Casters; Legs; Phillips Head Screw 10-24 X " (Inlet) - Grizzly G0671 Owner's Manual

4.
Attach the four casters to the legs by thread-
ing them into the bottom of the legs, as shown
in figure 15.
figure 15. Attaching casters.
5.
With assistance, turn the entire assembly
over so that the casters rest on the floor.
6. use eight ⁄ "-18 x 1" hex bolts, (16)
5
16
washers, and eight
each collector to the impeller housing with a
rubber gasket between the components, as
shown in figure 16.
⁄ " Flat Washers
5
16
Collector
⁄ "-18 x 1"
5
16
hex Bolt
figure 16. Collector mounted to impeller
housing.
-22-
Caster
leg
⁄ " flat
5
16
⁄ "-18 hex nuts to attach
5
16
impeller
housing
⁄ "-18
5
16
hex nut
rubber gasket
Note: The Model G0673 is a three-phase
machine. If it is wired out of phase, the
machine may not function properly. Proceed
to Test Run on Page 25 to determine if your
machine is wired in phase, then proceed to
Step 7.
The Models G0671 and G0672 are single
phase and cannot be wired out of phase. For
these models, continue below.
7. Attach the inlet to the top of the impeller
housing with the #10-24 x 3/8" phillips head
screw, as shown in figure 17.
figure 17. inlet mounted on impeller housing.
g0671/g0672/g0673 dust Collector
phillips
head screw