Download Print this page

Usb Cable (Option); Installing The Battery; Removing The Battery; Charging With The Desktop Charger - Hitachi WIRELESSIP5000 User Manual

Hide thumbs


User's Manual

4.4. USB cable (option)

If you connect your WIRELESSIP5000 to a PC with the USB cable shown in Figure 3, you
can charge and change settings.
When setting the WIRELESSIP5000, check whether your WIRELESSIP 5000 is directly
connected to your PC with the USB cable.

4.5. Installing the battery

Load the battery into the battery installation section at the rear of the WIRELESSIP5000,
then push in in the direction of the release button until it clicks into place.

4.6. Removing the battery

While holding down the release button, pull the battery toward the bottom of the WIRELES
SIP5000 and remove it.

4.7. Charging with the desktop charger

Step 1 Plug the AC adaptor into a wall socket, then connect the connector to the rear of the
battery charger.
Step 2 As Figure 4 shows, insert the WIRELESSIP5000 onto the charger until it clicks into place
and the LED lights up blue.
Note: As Figure 5 shows, you can also charge with the optional USB cable instead of with the A
C adaptor.
Hitachi Cable
Figure 3
Figure 4



  Also See for Hitachi WIRELESSIP5000

This manual is also suitable for: