Before You Begin - GE Kit IM-5SS Owner's Manual And Installation Instructions

Icemaker accessory kit
Table of Contents

Advertisement

Available languages

Available languages

ICEMAKER INSTALLATION INSTRUCTIONS C
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.
CAUTION –
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
• Remove the screw (A) that holds the electrical
plug cover in place. You will not need this screw
and cover.
• Remove the light shield insert (B) and discard it.
• Loosen the two mounting screws (C)
approximately 1/2" (13 mm). DO NOT REMOVE
THESE SCREWS.
C
Cut the fill tube extension (10) to this length for
Installation Instructions
C
Unplug the
Sharp knife
Pliers
B
A
Cover
removed
or K
2
INSTALL FILL TUBE EXTENSION
Cut the fill tube extension (10) to the length
(refer to the
C
sharp knife or single-edge razor blade and slide
it onto the fill tube against the stop.
C
3
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
.
C
4
3
8
(11.1 cm)
8
template in this section) with a
10
Hole for
wire tie
"
C

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Im-5ss

Table of Contents