Programming On And Off Times; Setting Something To Happen Every Day At The Same Time; Setting A Timed Event To Occur Once Only - X10 PHT02 Owner's Manual

Programming ON and OFF times

Setting something to happen every day at the same time.

After you have installed all of your Modules and checked that they are working instantly
from the Mini Timer you are ready to program timed events.
3. When you reach the desired time, press the ON or OFF rocker key for the Unit Code
you want to program.
For example: If you advance to 12:45 PM and then press the ON rocker key for number
2, you will program the Module set to Unit Code 2 to go on at 12:45 PM every day.
If you advance to 7:00 AM and then press the OFF rocker key for number 2, you will
program the Module set to Unit Code 2 to go off at 7:00 AM every day.
You can now advance to another time and press another ON or OFF rocker key (or the
same rocker key) to program another time. You can program 2 on times and 2 off times
for each of the 4 Modules. Note, if you try to set a third on or off time the display will read
18:88 to let you know you've done something wrong. To clear this, select Prog Review
and press the same rocker key you pressed when you tried to set the third on or off time.
You can program the same on or off time for multiple units by advancing to the time you
want and then pressing the appropriate ON or OFF rocker key for each Unit Code one
after the other without changing the time.

Setting a timed event to occur once only

If you press the "Once" button within 4 seconds after setting an ON or OFF time, you will
modify the program for that particular Unit Code to occur only once.
The event you have programmed will happen (at the time you have programmed) within
the next 24 hours, and will then be automatically cleared from memory and will not
happen again the next day.
You can program up to 2 "once" events for each Unit Code or mix Once and Daily
events for the same Unit Code (up to 2 on times and 2 off times for each Unit Code).
®
™
Tampa, FL33618
1. Set the Mode Switch to the "Prog Set" position.
2. Press the "Time" advance rocker key to advance to the
desired on or off time. When you first press the rocker the
time will advance by 1 minute. If you hold the right hand
rocker down the display will "speed up" so you can get to
the desired time faster. When you get close to the desired
time, you can "tap" the rocker a few times to get to the exact
time you want. If you overshoot, you can press the left hand
rocker to go back.
9
PHT02_6/98
Mini Timer