Reading The Event Log; Adjusting The View Brightness Of The Lcd - GE NetworX NX-148E User Manual

READING THE EVENT LOG

The control panel has an event log that can be retrieved using a master code. This log
contains a listing of the events along with date, time, and partition where the event
occurred.
To view the log, press r
Step 1
a code.
Step 2 Enter your master code. The LCD screen will now show the most recent
event.
To view the events from most recent to the oldest, press – .
Step 3
To view the events from the oldest to the newest, press • . The display
Step 4
contains the following information.
Event
Date
(Month/Day)
This screen shows an opening of Partition 3 on September 25
The [r] shows that this event is not programmed to be reported to the central
monitoring station. Refer to Appendix A on page 23 for a list of possible log messages.
ADJUSTING THE VIEW / BRIGHTNESS OF THE LCD
Enter r
Step 1
Step 2 Enter [master code]. The LCD will now prompt you to raise or lower the view.
Using the – • scroll keys to the right of the LCD, you can raise or lower
Step 3
the viewing angle of the text.
To advance to the Brightness option, press r The LCD will prompt you to
Step 4
brighten or dim the LCD lighting. Use the scroll keys again to adjust to
desired brightness.
When completed, exit by pressing r
Step 5
WWW.DIYALARMFORUM.COM
NX-148E LCD Keypad
Open
9/25 17:57
Time shown in
24-hour format
9 1 . The LCD Screen will prompt for a code.
9 0 . The LCD screen will prompt you for
75
P3*
User or Zone ID
Indicates partition
and indicates an
event not reported
at 5:27 p.m. by user 75.
t h
15