Advertisement
SERVICE INSTRUCTIONS
FOR YOUR SAFETY
Service must be performed by a qualified service agency.
REPLACING THE LIGHT BULBS
This stove uses 2 clear 120 Volt, 40 Watt, E-12 socket base light bulbs (small base,
chandelier candle type bulbs). The access plate is located on the back of the unit. For
convenience, if one of the light bulbs burns out, it may be easier to replace both of the light
bulbs at the same time.
WARNING: Do not exceed 40 Watts per bulb. Use of higher rated bulbs may result in a
fire, causing property damage, personal injury or loss of life.
1.
Turn off the power to the unit.
2.
Let the stove cool if it has been operating.
3.
Turn the stove so you are facing the back of the stove.
4.
Look for the access plate with the gold printing on it.
5.
Remove the 2 screws holding the access plate in position. Once you have
removed the 2 screws, lift the access plate so the 2 positioning tabs come free
of their slots. Once you have removed the access plate you can see and access the 2
40 watt chandelier bulbs.
6.
Remove each light bulb by unscrewing them out of the bases, turning them
counterclockwise. You can use one hand to hold the light socket in place, if required.
7.
Install the new light bulbs by turning each light bulb into the base clockwise. You can
use one hand to hold the light socket in place, if required.
8.
Replace the access plate by inserting the 2 tabs, pushing the plate up against
the stove back, and inserting the 2 screws.
9.
Turn the stove back so you are facing the front of the stove.
10. Turn the power on and enjoy the flame effect.
OPERATING INSTRUCTIONS
Your Muskoka
stove has the following functions:
®
Please note: Both the low heat
and the high heat switches
must be in the on position to
achieve high heat.
On/Off
Power to the unit
Low heat
700 watts
High heat
1400 watts
Advertisement
