INSTALLATION OF THE MEDIAMASTER
Connecting a Satellite Receiver and VCR
1 Connect a SCART lead between the main SCART socket on
the TV and the TV SCART socket on the Mediamaster.
2 Connect a SCART lead between the TV SCART socket
on the satellite receiver and the AUX SCART socket
on the Mediamaster.
3 If your TV is equipped with two SCART connectors
and the VCR also has a SCART; always use the second
SCART to connect the VCR to the TV.
4 Connect an RF lead from the RF output on the VCR to the TV
aerial input on the TV.
5 Connect an RF lead from the RF output on the satellite re-
ceiver to the RF input socket on the VCR.
6 Connect an RF lead from the TV/VCR output on the Media-
master to the RF input socket on the satellite receiver.
7 Connect an RF lead between the TV AERIAL input socket on
the Mediamaster and the network socket.
8 Connect the coaxial cable between the LNB and the LNB
socket on the satellite receiver.
Both the VCR and the satellite receiver must be tuned to dif-
ferent UHF channels than the Mediamaster when using RF-
The satellite receiver must be switched OFF (in standby
mode) when you want to watch digital cable channels
from the Mediamaster.
Connecting to the built in phone modem
The built in phone modem makes it possible for you to use inter-
• Connect a telephone cable (option) between the socket
marked TELEPHONE on the rear of the Mediamaster and the
ordinary telephone socket in the wall.
Connecting a HiFi System
• Connect an RCA/Cinch stereo cable from the AUDIO L R sock-
ets on the Mediamaster to the LINE, AUX, SPARE or EXTRA
input sockets on your HiFi system.
• If available you can connect an RCA/Cinch single cable from
the DIGITAL AUDIO socket on the Mediamaster to your HiFi
or Dolby Pro Logic system.
Note: To avoid interference you must use a screened video