SWITCH PANEL ASSEMBLY REPLACEMENT
- 9 & 12 CUP FOOD PROCESSORS -
To replace the switch panel assembly for the 9 and 12 cup food
processor:
1.
Unplug the power cord and remove the housing base.
2.
If necessary, remove the relay switch from its rubber
mounting block.
3.
Using a T-20 torx driver, remove the two (2) screws
securing the switch panel assembly to the motor housing
and switch assembly.
16
4.
Remove the switch panel assembly from the motor
housing. The switch panel assembly consists of the switch
panel overlay and switch panel bezel.
When removing the switch panel
NOTE:
assembly, care should be taken not to
lose the red neon lamp lens that slip-fits
into the switch assembly from the outside.
Remove the lens and set aside until re-
assembly.