Solid-State Drive - HP Chromebook14 Maintenance And Service Manual

Reverse this procedure to install the heat sink.

Solid-state drive

Description
32 GB
16 GB
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the keyboard/top cover (see
following components:
a. Speakers (see
b. Battery (see
c. WLAN module (see
d. Hall sensor board (see
e. System board (see
Remove the solid-state drive:
1. Turn the system board upside down, with the rear toward you.
2. Remove the Phillips PM2.0×2.5 (1) that secures the solid-state drive to the system board. (The
solid-state drive tilts up.)
56 Chapter 4 Removal and replacement procedures preliminary requirements
Keyboard/top cover on page
Speakers on page 26)
Battery on page 28)
WLAN module on page
Hall sensor board on page
System board on page
23), and then remove the
32)
39)
52)
Spare part number
740159-001
740158-001