Grandstream Networks GXP1405 User Manual page 29

Small-medium business ip phone
Hide thumbs Also See for GXP1405:
Table of Contents

Advertisement

DNS Mode
Primary IP
Backup IP 1
Backup IP 2
TEL URI
SIP Registration
Unregister on Reboot
Register Expiration
Reregister Before
Expiration
Local SIP Port
SIP Registration Failure
Retry Wait Time
SIP T1 Timeout
SIP T2 Interval
SIP Transport
SIP URI Scheme when
using TLS
Use Actual Ephemeral
Port in Contact with
TCP/TLS
Check Domain
Certificates
Remove OBP from
Route
Validate Incoming
Messages
Grandstream Networks, Inc.
The default is set to A Record. If users wish to locate the server by DNS SRV, users
may select SRV or NATPTR/SRV. When "Use Configured IP" option is selected, if
SIP server is configured as domain name, phone will not send DNS query, but use
"Primary IP" or "Secondary IP" to send sip message if at least one of them are not
empty.
This option applies only if "Use Configured IP" is selected, the phone will send DNS
query to the Primary IP. Insert IP address here.
Insert the first back up IP here.
Insert the second back up IP here.
Default is "Disabled". Users can enable it or select USER=PHONE.
This parameter controls sending REGISTER messages to the proxy server. The
default setting is "Yes".
Default is "No". If set to "Yes", the SIP user's registration information will be cleared
on reboot.
This parameter allows user to specify the time frequency (in minutes) that
GXP1400/1405 refreshes its registration with the specified registrar. The default
interval is 60 minutes. The maximum interval is 65,535 minutes (about 45 days).
This parameter allows user to specify the time frequency (in seconds) that
GXP1400/1405 sends out a re-registration request before the Register Expiration.
By default is 0 second.
This parameter defines the local SIP port used to listen and transmit. The default
value is 5060.
Retry registration if the process failed. Default is 20 seconds.
RFC 3261 SIP T1 timer. Default is 0.5 second.
RFC 3261 SIP T2 timer. Default is 4 seconds.
Choose SIP Transport between UDP and TCP. Default is UDP.
Select "sip:" or "sips:". Default is "sips:".
Enable to use actual ephemeral port in contact with TCP/TLS. Default is "No".
Enable to check the domain certificate. Default is "No".
The SIP Extension notifies the SIP server that it is behind a NAT/firewall.
This configuration selects whether or not the incoming messages should be
validated.
GXP1400/1405 User Manual
Firmware version: 1.0.1.83
Page 28 of 36
Last Updated: 08/2011

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gxp1400Gpx1405

Table of Contents