Conversion To Liquified Petroleum Gas; Grounding Instructions - Kenmore 790.7042 Series Use & Care Manual

See the INSTALLATION
INSTRUCTIONS packaged with this
range for complete installation and

grounding instructions.

Conversion to Liquefied Petroleum Gas (or L.P. Gas)
The natural gas range is designed to allow for conversion to
Liquefied Petroleum (L.P.) Gas. If L.P. conversion is needed,
contact 1-800-4-MY-HOME® for assistance. The L.P.
Conversion Kit is provided with this range and is located on the
left lower REAR (back side) panel of the range. Before installing
the kit be sure to follow the L.P. Installation Instructions
carefully.
Important Safety Notice
The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known
to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure
to such substances.
Important Safety Instructions
Grounding Instructions
Avoid fire hazard or electrical shock. Do not use an adapter plug, an
extension cord, or remove grounding prong from electrical power cord. Failure to follow
this warning can cause serious injury, fire or death.
This appliance is equipped with a 3-prong grounding plug for your
protection against shock hazard and should be plugged directly into a properly grounded
receptacle. DO NOT cut or remove the grounding prong from this plug. For personal
safety, the range must be properly grounded. For maximum safety, the power cord must
be plugged into an electrical outlet that is correctly polarized and properly grounded.
If a 2-prong wall receptacle is the only available outlet, it is the personal responsibility of
the consumer to have it replaced with a properly grounded 3-prong wall receptacle
installed by a qualified electrician.
(electric ignition models only)
Personal injury or death from electrical shock
may occur if the range is not installed by a qualified installer or
electrician.
Any additions, changes or conversions
required in order for this appliance to satisfactorily meet the
application needs must be made by Sears Service.
5