Connection To The Host Computer; Rs232 Connection - Datalogic F732-E Wizard User Manual

Hide thumbs Also See for F732-E Wizard:
Table of Contents

Advertisement

CONNECTIONS
2.2

CONNECTION TO THE HOST COMPUTER

CAUTION
2.2.1

RS232 Connection

To connect the F952 cradle to the host computer, proceed as
indicated below:
1-
Connect the cable to the serial port of the host computer.
2-
Connect the other end of the same cable (RJ connector) to the
RS232 port of the cradle (point D in the previous figure).
3-
Insert the power-supply plug into the jack on the base of the
cradle (point C in the previous figure).
4-
Attach the power supply to a power outlet.
5-
Turn on the cradle (point B in the previous figure) and the
computer.
6-
Put the F732-E terminal into the cradle and, if necessary, wait
for battery recharging.
NOTE
Before proceeding with this phase, make sure
that both the computer and the terminal are
switched off.
For correct communication with the terminal, it
is necessary that both the PC and terminal
serial communication parameters share the
same value. Default parameters are: baud rate
= 9600, data bits = 8, parity = none, stop bit = 1.
2
7

Advertisement

Table of Contents
loading

Table of Contents