Attaching The Paper Support; Plugging In The Stylus Scan - Epson Stylus Scan 2500 Setup Manual

Hide thumbs Also See for Stylus Scan 2500:
Table of Contents

Advertisement

3.
Slide the transportation lock out, as illustrated below, to release the scanner
carriage.
Note:
Slide the transportation lock in to lock the scanner carriage before transporting the
Stylus Scan.
4.
Close the maintenance cover and document cover.

Attaching the Paper Support

Insert the paper support into the slots at the rear of the Stylus Scan.

Plugging in the Stylus Scan

1.
Make sure that the Stylus Scan is turned off.
2.
Check the label on the back of the Stylus Scan to make sure the voltage required
c
by the Stylus Scan matches that of the electrical outlet you plug it into. Also, make
sure that you have the correct power cable for your power source.
Caution:
It is not possible to change the Stylus Scan's voltage. If the rated voltage
and your outlet voltage do not match, contact your dealer for assis-
tance. Do not plug in the power cord.
3.
If the power cord is not attached to the Stylus Scan, connect it to the AC inlet at
the back of the Stylus Scan.
4.
Plug the power cord into a properly grounded electrical outlet.
Setting up your Stylus Scan 2500
9

Advertisement

Table of Contents
loading

Table of Contents