In Use; Care And Maintenance; Bulb Replacement; Battery Care - Russell Hobbs 12051-56 Instructions Manual

diagrams
1 switch
2 cover
3 front
4 rear
5 motor unit
12 Lower the cover on to the motor unit.
13 Align the pointer ) on the cover with the open padlock U, push the cover down, then turn it
to align the pointer ) with the closed padlock L.
C IN USE
14 Hold the mill over the food.
15 Press the switch to start the motor, release it to stop.
16 Don't run the motor for more than 1 minute, or it may overheat. After 1 minute, switch off for
at least 3 minutes, to let the motor cool.
C CARE AND MAINTENANCE
17 Wipe the outside surfaces with a clean dry cloth.
18 Don't let the appliance get wet or damp.
19 Don't put any part of the appliance in a dishwasher.
C BULB REPLACEMENT
20 Turn the whole mill upside down.
21 Grip the plastic surrounding the bulb, and pull it straight up.
22 Fit the new bulb in its place.
C BATTERY CARE
23 Check that the batteries are fitted correctly – there's a guide inside the battery compartment.
24 Don't leave dead batteries in the appliance, they may leak caustic gunge over the product
and surroundings.
25 Unless you're using the batteries regularly, it's best to remove them altogether.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in electrical
and electronic goods, appliances marked with this symbol mustn't be disposed of with
unsorted municipal waste, but recovered, reused, or recycled.
6 batteries (not supplied)
7 spindle
8 peppercorns
9 grinder
10 bulb
11 base
3
12 underneath
13 knob
14 coarse
15 fine