Daikin SUPER MULTI NX CTXS07JVJU Service Manual page 127

FDXS-D Series
 To use ON TIMER operation
• Check that the clock is correct. If not, set the clock to the
present time.
1. Press "ON TIMER button".
is displayed.
blinks.
2. Press "TIMER Setting button" until the time
setting reaches the point you like.
• Every pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly.
3. Press "ON TIMER button" again.
• The TIMER lamp lights up.
 To cancel ON TIMER operation
4. Press "CANCEL button".
• The TIMER lamp goes off.
 To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
ATTENTION

In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
119
(Example)
Combined
SiUS12-928_B
1, 3
2
4
17
C: 3P196326-10
Operation Manual