Chapter 9. Configuring Firewall/NAT Settings
9.4.1
Outbound ACL Rule Configuration Parameters
Table 9.2 describes the configuration parameters available for firewall outbound ACL rule.
Field
ID
Add New
Rule Number
Action
Allow
Deny
Mave to
This option allows you to set a priority for this rule. The Internet Security Router Firewall acts on
packets based on the priority of the rules. Set a priority by specifying a number for its position in the
list of rules:
1 (First)
Other numbers
Source IP
This option allows you to set the source network to which this rule should apply. Use the drop-down
list to select one of the following options:
Any
54
Figure 9.9. Outbound ACL Configuration Page
Table 9.2. Outbound ACL Rule Configuration Parameters
Description
Click on this option to add a new 'basic' Firewall rule.
Select a rule from the drop-down list, to modify its attributes.
Select this button to configure the rule as an allow rule.
This rule when bound to the Firewall will allow matching packets to pass
through.
Select this button to configure the rule as a deny rule.
This rule when bound to the Firewall will not allow matching packets to
pass through.
This number marks the highest priority.
Select other numbers to indicate the priority you wish to assign to the rule.
This option allows you to apply this rule to all the computers in the local
Internet Security Router User's Manual