Download Table of Contents Print this page

Husqvarna ST230E Operator's Manual page 19

Walk-behind snow throwers

Advertisement

Table of Contents
SERVICE AND ADJUSTMENTS
TO REMOVE WHEELS (See Fig. 25)
Remove the wheel pin and retainer pin and remove
wheel from axle.
NOTE: To seal punctures or prevent flat tires due to slow
leaks, tire sealant may be purchased from your local parts
dealer. Tire sealant also prevents tire dry rot and cor ro sion.
WHEEL PIN (INSTALL
IN OUTER HOLE OF
AXLE ONLY)
RETAINER
PIN
WHEEL
TO ADJUST CABLE TENSION (See Fig. 26)
Adjust cable tension by turning the adjuster turn buckle,
located on the right hand cable. Grasp the long section
tightly and turn the short section to lengthen the adjuster.
Adjust until cable is snug.
TO ADJUST TRACTION BELT AND AUGER BELT
TENSION
If the traction or auger belt is slipping because it is not tight
enough when engaged, the tension can be increased by
adjusting the spring location in the control rod. Unhook
the rod from the control lever and move the spring at the
bottom of the rod one or two holes closer to the top of the
rod. This effectively shortens the rod and increases the
belt tension. (See "INSTALL AUGER CONTROL ROD" in
the Assembly section of this manual.)
OUTER HOLE
AXLE
WHEEL HUB
FIG. 25
ADJUSTER TURN
BUCKLE
FIG. 26
ENGINE
SEE ENGINE MANUAL.
CARBURETOR
Your carburetor is not adjustable. Engine performance
should not be affected at altitudes up to 2,134 meters. If
your engine does not operate properly due to suspected
carburetor problems, take your snow thrower to a service
center/department.
ENGINE SPEED
Never tamper with the engine governor, which is factory set
for proper engine speed. Overspeeding the engine above
the factory high speed setting can be dangerous and will
void the warranty. If you think the engine-governed high
speed needs adjusting, contact a service center/depart-
ment, which has the proper equipment and experience to
make any necessary ad just ments.
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1650exl

Table of Contents