Brother MFC-8880DN User Manual page 149

Hide thumbs Also See for MFC-8880DN:
Table of Contents

Advertisement

Error Message
Cover is Open
Disconnected
Document Jam
Drum Error
DR mode in Use
(except New Zealand)
Duplex Disabled
Faxability On
For New Zealand
Fuser Error
Jam Duplex
Jam Rear
Jam Inside
Jam MP Tray
Jam Tray 1
Jam Tray 2
Cause
The fuser cover is not closed
completely or paper was jammed
in the back of the machine when
you turned on the power.
The other person or other
person's fax machine stopped the
call.
The document was not inserted
or fed correctly, or the document
scanned from the ADF was too
long.
The corona wire on the drum unit
needs to be cleaned.
The drum unit has reached the
end of its life.
The machine is set to Distinctive
Ring mode. You can not change
the Receive Mode from Manual to
another mode.
The duplex tray is not installed
properly.
The machine is set to Faxability
mode. You can not change the
Recieve Mode from Manual to
another mode.
The temperature of fuser unit
does not rise at a specified
temperature within specified time.
The fuser unit is too hot.
The paper is jammed in the
duplex tray.
The paper is jammed in the back
of the machine.
The paper is jammed inside the
machine.
The paper is jammed in the MP
tray of the machine.
The paper is jammed in the paper
tray of the machine.
Troubleshooting and routine maintenance
Action
Close the fuser cover of the machine.
Make sure paper is not jammed inside
the back of the machine, and then close
the fuser cover and press Start.
Try to send or receive again.
See Document jams on page 144 or Using
the automatic document feeder (ADF)
on page 21.
Clean the corona wire on the drum unit. (See
Cleaning the corona wire on page 154.)
Replace the drum unit. (See Replacing the
drum unit on page 162.)
Set Distinctive Ring to off.
For Austlaria, see Telstra
®
Duet
(Distinctive Ringing) on page 54.
For Other countries, see Distinctive Ringing
(For Singapore and Hong Kong) on page 59.
Remove the duplex tray and install it again.
Set Faxability to off.
See FaxAbility on page 57.
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
The machine can be turned off for up to 60
hours without losing faxes stored in the
memory. (See Transferring your faxes or Fax
Journal report on page 143.)
(See Paper jams on page 145.)
(See Paper jams on page 145.)
(See Paper jams on page 145.)
(See Paper jams on page 145.)
(See Paper jams on page 145.)
C
®
®
FaxStream
139

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mfc-8890dw

Table of Contents