Upgrading An Agp Screen Controller Or The Gpa Memory; Installing Network Board With Wol - Fujitsu Siemens Computers D1215 Technical Manual

Add-on modules

Upgrading an AGP screen controller or the GPA memory

If your system board has only one PCI slot then only one GPA memory board and no
i
AGP screen controllers are supported by the system board.
If your system board is provided with three PCI slots then the system board supports AGP
screen controllers with 1x, 2x and 4x AGP modes and GPA memory boards.
The GPA memory improves the speed of the screen controller on the system board with 3D
applications.
Ê
Insert the memory module into the AGP slot (1)

Installing network board with WOL

Ê
Install the network board as described in the operating manual for your unit.
Ê
Push the WOL cable onto the WOL plug connector of the system board.
To use the WOL functionality of a network board the power supply must provide a
i
5 V auxiliary voltage of at least 1 A. If the system board was not already
incorporated in a device when you bought it you must check whether your power
supply can provide the auxiliary voltage.
You may find further information in the supplied description of the network board.
14 - English
A26361-D1215-Z120-6-7419