Whirlpool EV150FXR User Manual page 6

Removing the bottom trivet...
To remove:
1 Lift front of trivet out of supports
2 Pull out
To replace:
1
Positton back of trivet on the rear wall supports
2 Lower front in+0 L3lace
The key eject lock...
Energy saving tips...
You can help your freezer use less electricIVy
l
Check door gasket and level freezer to assure a
good door seal
l
Clean the car ,derlser
coils
regcllarly
l
Keep door openings to a minimum Remove several
items at one time Keep contents organized to elimi-
nate searching
l
FIII to capaci+v Follow recommended procedures
for freezlng foods See pages 8 and 9
The signal light...
automatically warns of any unexpected
power failure.
Signal Light
/
If the signal light is not glowing, immediately check.
l
for power interruption,
l
for an unplugged power cord,
l
for a burned out signal light
Lift the Front,
Then Pull Out.
car help reduce the hazard of child
ertrapmept
To lock or unlock the freezer you must hold the
key
in the lock while turning The lock
IS
spring
loaded so the key cannot be left in the lock
If the key 1s lost, contact your WHIRLPOOL
dealer for a replacement Always give the com-
plete model and serial number of your freezer
when requesting a replacement key.
l
Set Temperature Control to provide temperatures
around 0°F ( 17.8 "C) There is no need to store
foods below 0°F
l
Keep door locked to ensure door closure
l
Do not let frost build up to more than
inch (6 mm]
thick Efficiency IS reduced
l
Keep Power Saving Control on OFF when humlclty
IS
IObV
To replace burned out signal light:
I. Unplug power cord from outlet
2. Open the freezer door
3. Unplug burned out light and replace with one of
same wattage and size Signal light can be
ordered from your WHIRLPOOL dealer,
Part No. 530584
4 Close freezer door and plug power cord tnto outlet.
6