Password - Q-See QS434 User Manual

DEVICE OPERATION
•
If using the DEFAULT, click APPLY.
•
If setting a CUSTOM DST, use the drop-down menus to select a week and month for the start and end
times.
3) Click APPLY. Click CLOSE in the confirmation window.
4) Click EXIT in each menu until all windows are closed. Type date via numeric key.

8. PASSWORD

When you first startup your system, you are automatically logged in as the ADMIN under Device ID000000. The
system employs two user authorities connected to a Device ID. The authorities are as follows:
• ADMIN (administrator): Has full control of the system, and can change both administrator and user passwords and
enable/disable password checking
• USER (normal user): Only has access to live viewing, search, playback, and other limited authorities. For security
reasons, it is highly recommended to enable passwords on your system. If you enable passwords, you must
select a 6-digit ADMIN password and a 6-digit USER password.
ATTENTION: By default, passwords are disabled on the system. You will not need a password to log in or access
menus. You will not need a password to access your system using the browser-based remote software.
You can change the Device ID and password of the ADMIN and the USER from the Password menu.
To open the Password/security menu:
1) Right-click anywhere onscreen to open the Sub-Menu and select MAIN MENU.
2) Click BASIC. The Basic Setup Menu opens.
3) Click PASSWORD. The Password/Security menu opens.
Figure 3.5.24
25 | P a g e
Model #: QS434