Configuring Recording Settings; Record Mode Setup Screen; Figure 46 - Record Mode Setup Screen - Mitsubishi Electric DX-TL4U User Manual

Digital recorder

Table of Contents

User's Manual

NOTE: Selecting the PTZ in the RS232 field only defines the RS-232C port as being used for

the PTZ camera connections. Select the PTZ device in the Camera Setup screen.

Configuring Recording Settings

NOTE: When the DVR is recording video, the REC LED on the front panel is lit and the

displays on each camera screen.

Your DVR offers a variety of flexible recording modes. You can set it up to record all the time or to

only record events. It can be set up to continue recording once the hard disk drive is full by

recording over the oldest video, or you can set it up to alert you when the hard disk is full and stop

recording.

Figure 46 — Record Mode Setup screen.

Highlight the box beside Resolution and press the

button.

NOTE: The maximum recording speed is 30 images per second (25 ips for PAL) when the

resolution is set to Standard. However, when set to High, the recording speed will be

decreased to 15 images per second (12.5 ips for PAL).

Highlight the box beside End Of Disk and press the

button. This toggles between Overwrite

and Stop. When in the Overwrite mode, the DVR continues recording when the hard disk drive is

full by overwriting the oldest video. When in the Stop mode, the DVR stops recording when the

hard disk drive is full.

If the DVR is set to the Stop mode, you can set it to beep or activate the Alarm Out port when the

hard disk drive is full. Highlight the box beside On Disk Full Beep and press the

button to

toggle between On and Off. Highlight the box beside On Disk Full Alarm Out and press the

button to toggle between On and Off.

Table of Contents