Front Pulley
The front pulley is installed on the transmission output shaft using a 5/16" x 1-7/8" key,
set screw, SKX1.5 taper lock bushing and three 5/16" x 1-¼" grade 8 bolts and washers.
Front Pulley
Rear Pulley
The rear pulley is mounted on the axle spool with four ½" x 2 1/2" socket head bolts
and washers. There are two keyway slots in the pulley that match the keyways in the
axle spool that assist in stabilizing the rear pulley.
AXLE PULLEY and HOUSING ASSEMBLY
© Copyright Boss Hoss Cycles, Inc. 2004. All Rights Reserved.
FINAL DRIVE
Fig. 7-3
FIG 7-4
66