Convenient Functions - Citizen PROMASTER NAVISURF CTZ-B6804 Instruction Manual

<Split Time Measurement>
1. The chronograph is started and stopped with
button .
A
2. When button is pressed during measurement,
C
the split time will be displayed for 10 seconds.
(The word "SPLIT" will flash during display of the
split time.) Split time can
be measured as many
times as desired.
3. The chronograph can be
reset by pressing button
when it is stopped.
C
* When button is pressed during display of the
C
split time, the next split time will be displayed.
12. USE OF ALARMS 1 AND 2 (AL-1/AL-2)
■ The procedure for setting the alarm for alarm 1
and alarm 2 is exactly the same. Only the beeping
tone is different. Once set (turned ON), the alarm
will sound for 15 seconds at the same time every
day.
[Alarm ON Display]
3. mark "ON" or "OFF" will flash on the digital display.
At this time, press button
or OFF.
4. Press button until the digit of the display you
A
want to set flashes.
5. Press button to set to the correct setting
C
(continuously pressing button
display to advance rapidly).
6. Push in button to the normal position.
M
<Turning Off the Alarm>
Pressing any of button
alarm sound.
• You can hear to the sound of the alarm at any
time by pressing buttons
when the watch is in the alarm mode (alarm
sound monitor).
• Since a 12 hour display will also be used for
the alarm mode when the time mode is set to a
12 hour display, make sure that AM and PM are
set correctly.
<Setting Procedure>
1. Press button and
M
switch the watch to the
"AL-1" or "AL-2" mode.
2. Press button or
A C
display the name of the
city for which you want
to set the alarm.
3. Pull out button . The
M
to select either ON
C
will cause the
C
, or will turn off the
A B C
and simultaneously
A C
13. DISPLAY OF BUTTON FUNCTIONS
This watch is provided with a digital display that
indicates the function
of each button. Refer
to this display when
desiring to know the
function of a particular
button.

14. CONVENIENT FUNCTIONS

When display becomes illegible due to
overlapping of digital display and analog hands:
• This watch allows the hour and minute hands to
be retracted when the display becomes difficult to
see as a result of the hour and minute hands
overlapping the digital display (hand retract
function).
to
~Procedure~
1. Press button
"H.R." is displayed on the digital display for the
function of button
will begin to move toward the 12:00 position.
2. Once the hour and minute hands have been
moved to a location that does not obstruct the
view of the digital display, press button
and stop the movement of the hands. (If button
is not pressed, the hands will continue to
B
move until they reach the 12:00 position.
~Cancellation of Hand Retract Function~
• Press button
✰ The letters "H.R." will
flash during the time
the hand retractor
function is activated.
✰ H.R. is the abbreviation for "Hand Retract".
When the watch shows unusual display
• When there appears to be a malfunction or
abnormality in the display or operation of the watch
(such as a portion of the display not being shown
or the alarm continuing to sound), perform the full
reset and hand zero positioning described below.
for at least 2 seconds when
B
. The hour and minute hands
B
one more time.
B
again
B