Today's detergents for dishwashers are almost ex-
clusively low-alkaline concentrated detergents with
natural enzymes in tablet or powder form.
Using 50°C dishwashing cycles in conjunction
with these concentrated detergents reduces
pollution and is good for your dishes, as these
dishwashing cycles are specially matched to
the dirt-dissolving properties of the enzymes
in concentrated detergents. It is for this reason
that using 50 °C dishwashing cycles in con-
junction with concentrated detergents can
achieve the same cleaning results that can
otherwise only be achieved using 65 °C cy-
Detergent tablets from different manufactur-
ers dissolve at different rates. For this reason,
some detergent tablets do not attain their full
cleaning power during short cycles. Therefore
please use dishwashing cycles with pre-wash
when using detergent tablets.
Using 3in1 detergents
These products are detergents with a combined
cleaning, rinsing and salt function.
If you want to use 3in1 products
1. There is no need to fill up with special salt or rinse
2. Set the water softener to water hardness range "I".
3. Set the rinse aid dosage to "1".
Before the start of the dishwashing cycle put 3in1
detergent in the detergent dispenser.
If you do not want to use 3in1 products
If you want to stop using 3in1 products, please do
• Fill up the dispensers for salt and rinse aid again.
• Switch the water softener to the highest setting
and perform up to three normal cycles without
loading any dishes.
• Then set the water softener to the water hardness
in your area.
If you want to use 4in1 products
When using "4 in 1" detergents that integrate also
anti- glass corrosion agent into "3 in 1" formula,
please follow the same indication as given for "3 in