Table of Contents
Advertisement
Electrical connection
The unit is preset to work with a volt-
age of single phase 230 V.
Before making the connection make
sure that:
- the energy power available in the us-
er's house is sufficient for the normal
supply of this appliance (see rating
plate).
- the unit is correctly connected to
earth through a suitable plug and
according to the installation country
Laws.
- the socket or the omnipolar switch
used for the connection must be
easilv reached with the installed ap-
pliance.
The appliance is supplied with elec-
tric cable, therefore you will have to fit it
with a standard plug, suitable for the to-
tal electric load shown on the rating
plate. The plug is to be inserted into a
suitable wall socket.
If you wish to directly connect to the
mains, you have to interpose an
omnipolar switch with a minimum open-
ing between contacts of 3 mm, between
the unit and the mains, complying with
the existing regulations. The brown live
wire (originating from the clamp of the
appliance junction box) must always be
connected to the phase of the mains
supply. In any case, the supply cord
must be positioned in such a way as it
doesn't reach in any point a temperature
higher by 50°C than the room tempera-
ture.
Replacement of the electric
cable
Should the supply cord need to be
replaced, use only the following cable
types: H07 RN-F, H05 RN-F, H05 RR-
F, H05 VV-F, H05 V2V2-F (T90), H05
BB-F. It is necessary that the yellow/
green earth wire is about 2 cm longer
than the live and neutral ones (Fig. 18).
After the connection, test the heating el-
ements for about 3 minutes to ensure
that they are working correctly.
The manufacturer refuses any
responsability in cases where nor-
mal safety measures are not ob-
served.
Phase
Ground (yellow - green)
electrolux 35
Neutral
wire
Fig. 18
Advertisement
Table of Contents
