Replacing Bulbs - Ducati 748 Owner's Manual

Replacing bulbs

Before replacing a burnt-out bulb, make sure that the
new one complies with voltage and wattage as specified
on page 69, "Electric System", for that lighting device.
Always check for new bulb proper operation before
refitting removed parts.
Headlamp
To gain access to headlamp bulbs proceed as follows:
Disassembly:
low beam bulb (fig. 55): remove the rubber cover (1).
Press the lower quick-release button to disconnect the
connector (2).
L.h. high beam bulb (fig. 56): disconnect the connector
(3) of the white bulb cable from the front wiring, remove
the rubber cover (1) from the headlamp body and pull out
the bulb cable.
Note
The black ground mass cable connector does not
need to be disconnected to replace the headlamp bulbs.
Release the clip (4) that secures the bulb and remove it
from the socket (fig. 55 and 56).
4
2
1
E
fig. 55
4
3
1
fig. 56
51