Download  Print this page

Setting The Gear Change And Rear Brake Pedals - DUCATI 748 Owner's Manual

Hide thumbs

Advertisement

Setting the gear change and rear brake pedals

(fig. 15 and 16)
The gear change and rear brake pedals can be adjusted
to suit the preferred riding position of each rider.
To set the gear change pedal, lock linkage (1) and loosen
the check nuts (2) and (3).
Note
Nut (2) has a left-hand thread.
Fit an open-end wrench to the hexagon portion of linkage
(1). Rotate linkage until setting pedal in the desired
position.
Tighten both check nuts onto linkage.
To set the rear brake pedal,
loosen check nut (4).
Turn pedal travel adjusting screw (5) until pedal is in the
desired position.
Tighten check nut (4).
Work pedal by hand to make sure it has 1.5 - 2 mm free
play before brake begins to bite.
If not so, set the length of cylinder linkage as follows.
Loosen the check nut (6) on cylinder linkage.
Tighten linkage into fork (7) to increase play, or unscrew
linkage to reduce it.
Tighten check nut (6) and check pedal free play again.
E
fig. 15
fig. 16
19

Advertisement

Table of Contents

   Also See for DUCATI 748

This manual is also suitable for:

998998s final edition748s998s

Comments to this Manuals

Symbols: 0
Latest comments: