Table of Contents
Advertisement
8 electrolux
Operation
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a pan on the pan
support.
To light a burner:
Push the electric ignition push button which
is marked by a little spark ( ).
At the same time turn the relevant control
knob anticlockwise to maximum position
(
), then push it down to ignite the burner.
Then adjust the flame as required.
If the burner does not ignite, turn the
control knob to zero, and try again.
When switching on the mains, after
installation or a power cut, it is quite
normal for the spark generator to be
activated automatically.
In the absence of electricity, ignition can
occur without the electrical device; in this
case, approach the burner with a flame,
push the relevant knob down and turn it anti-clockwise until it reaches
the "maximum" position.
Do not keep the control knob pressed for more than 15
seconds. If the burner does not light even after 15 seconds,
release the control knob, turn it the "off" position ( ) and
wait for at least one minute before trying to light the burner
again.
A A A A A - Burner cap
B B B B B - Burner crown
C C C C C - Ignition electrode
D D D D D - Thermocouple
Advertisement
Table of Contents
