Bobbin Winding - Husqvarna Viking Emerald 122 User Manual

2
1
3
5
7
12

Bobbin Winding

1
Pull the handwheel out to put the
machine in bobbin wind position (the
needle will not go up and down).
2 Guide the thread around the bobbin
2
thread tension guide into the tension
disk.
3
Thread through the hole in the
bobbin from the inside to the outside.
Put the bobbin on the bobbin winder
spindle with the free end of the
thread coming out at the top.
4 Slide the bobbin winder spindle to the
4 right.
NOTE:
winder spindle while the machine is
running.
5
With the free end of the thread held
in your hand, press the foot control.
Stop the machine when the bobbin
has made a few turns, and cut the
6
thread as illustrated.
6
Press the foot control again. When
the bobbin is fully wound, it will stop
automatically. Slide the bobbin winder
to its original position by moving the
spindle to the left, and cut the thread
as illustrated.
7 Push in the handwheel.
To use the vertical spool pin, set the felt
and the spool as shown above.
a
b
c
3
1
Do not move the bobbin
Vertical spool pin
Spool pin felt
Spool pin hole
b
a
c