Related Manuals for Electrolux EHG678 Series
Summary of Contents for Electrolux EHG678 Series
- Page 1 I N S T R U C T I O N M A N U A L B U I L T - I N H O B Models: EHG678* • EHG978* • EHM684* • EHM984* • EHG977* • EHG983* • EHG682* • EHG982* *Denotes colour: W=White, X=Stainless Steel...
- Page 2 M A N U A L Congratulations and thank you for choosing an Electrolux Product. We are sure you will find your new cooktop a pleasure to use and a great asset to your cooking. Before you use the cooktop, we recommend that you read through the whole user manual which provides the description of the cooktop and its functions.
-
Page 3: And Care
Do not boil food too rapidly. A strong boil will not cook food any faster, and will waste energy. UTENSILS All normally available utensils; aluminium, stainless steel, cast iron, ceramic, etc., may be used on your new gas or electric element model cooktop. Ensure that the utensils are steady and have flat bases to avoid dangerous spill-over of hot liquids and wasted energy. -
Page 4: Installation
SERVICING INSTRUCTIONS Table 1.0 FAULT POSSIBLE CAUSE REMEDY SOLID HOTPLATE (Where fitted) Burner will not light even though the Gas supply valve turned off. Turn on gas supply to It is most important that the sealed sparker is working. appliance. Port blockage in ignition Ensure that ports in ignition hotplate is kept clean and correctly... -
Page 5: Gas Connection
When the appliance is in position swing the clamps under the bench top and lightly tighten. (Fig. 6) 5. RUBBER SEAL This is to be applied around the edge of the hob (Fig. 7) leaving a 400mm cutout on a hidden edge of the unit. This gap is to allow air to enter for ventilation. - Page 6 To convert the appliance for use with Citigas follow the conversion procedure. A Qualified Technician should carry out this procedure and use a Conversion Kit available from Electrolux The Kit contains - •...
-
Page 7: Conversion Procedure
CONVERSION PROCEDURE 1. Disconnect the appliance from main electrical power supply. 2. Lift off trivets, burner caps, burner crowns, and control knobs. 3. Remove the existing injectors and fit the injectors appropriate for the required gas type as specified in the table. - Page 8 MANUFACTURER: Electrolux Home Products Pty Ltd P.O. Box 21 Prospect South Australia 5082 P/No. 342-1-487 ECN 04A076G...