1. Detergent dispenser drawer
Programme option buttons
Depending on the programme, different option
buttons can be combined.
When these buttons are pressed, the corresponding
lights come on. When they are pressed again, the
lights go off.
If an incompatible option with the selected
programme has been chosen, the corresponding
light flashes for about 2 seconds.
The option buttons:
EASY IRON and
must be selected after the required programme has
been chosen, by turning the programme selector
(see section 9) and before starting the machine, by
START / PAUSE.
By pressing this button you have the possibility of
choosing between the following options:
PRE-WASH option: Adds a pre-wash phase
at the start of the cycle with water heating to 30° C.
In COTTON and SYNTHETIC cycles, performs a
short spin before passing to the washing phase.
This option cannot be selected for WOOL.
QUICK WASH option: Using this option, you
can get good washing results in a short period of
time, since with option, the COTTON,
SYNTHETICS, and DELICATES programmes are
modified in order to obtain short washing times
(recommended for small or lightly-soiled loads).
This modification consists of reducing the number of
rinse cycles (one less) and also increases the water
level used in the remaining two rinse cycles.
If both lights (
WASH) are not illuminated the programme will run
EASY IRON button
This option is available for COTTON, LINEN and
SYNTHETIC programmes. By selecting this button
the machine will inserts a impulse spin and an
anticrease phase after final spin in COTTON
programs. In SYNTHETIC programs, by selecting
this button the machine will inserts a cool-down after
washing phase and an anticrease phase after final
In case you want to avoid wrinkles in your laundry
after washing,the EASY IRON option must be
SUPER RINSE button
Can be used with all programmes, except wool.
The machine will add 2 rinses to the selected
This option is recommended for people who are
allergic to detergents and in areas where the water
is very soft.
START / PAUSE button
After selecting the required programme, by the
programme selector (see section 9), press this
button to start the machine; the corresponding light
stops flashing and will keep lighting until the
To interrupt the running programme, depress
START / PAUSE button: the corresponding
light starts to flash.
To restart the programme from the point at which it
was interrupted, press
START / PAUSE button