Electrical Connections - Electrolux 92558 G Instruction Booklet

Gas hob

Electrical connections

The appliance is designed to be connected to 230-240 V monophase electricity

supply.

The connection must be carried out in compliance with the laws and regulations

in force.

Before the appliance is connected:

1) check that the main fuse and the domestic installation can support the load

(see the rating label);

2) check that the power supply is properly earthed in compliance with the current

rules;

3) check the socket or the double pole switch used for the electrical connection

can be easily reached with the appliance built in the furniture unit.

The appliance is supplied with a connection cable provided with a plug, able to

support the load marked on the identification plate. The plug has to be fitted in

a proper socket.

If connecting the appliance directly to the electric system, it is necessary that

you install a double pole switch between the appliance and the electricity supply,

with a minimum gap of 3 mm. between the switch contacts and of a type suitable

for the required load in compliance with the current rules.

The connection cable has to be placed in order that, in each part, it cannot reach

a temperature 50 °C higher than the room temperature.

The brown coloured phase cable (fitted in the terminal block contact marked

with "L") must always be connected to the network phase.

Electrical connections

Table of Contents

92558