Advertisement
Table of Contents
Installation
Important
This appliance must be installed by qualified personnel.
The installer shall verify the satisfactory operation of the ignition system on all
burners both individually and in combination.
The manufacturer will not accept liability, should the above instructions or any of
the other safety instructions incorporated in this book be ignored.
Regulations
This appliance shall be installed in accordance with the manufacturer's installation
instructions, local gas fitting regulations, municipal building codes, AS5601 (AG601)
and any other relevant statutory regulations.
Data label
The data label is located on the bottom of the hob. This appliance is suitable for
Natural or Universal LPG. Ensure that the gas supply matches the data label. A
duplicate of the data label is supplied in the packaging of the user manual and
must be attached to readily accessible adjacent surfaces of the appliances.
Connection to the gas supply
Gas connection must be carried out in conformity with the regulations in force.
The appliance leaves the factory tested and regulated for the type of gas indicated
on the plate which is situated in the lower position near the gas connection tube.
Ascertain that the type of gas with which the appliance will be supplied is the
same as that indicated on the plate.
If different carry out all the operations according to the indications cited in the
paragraph "adaption to different types of gas".
For a maximum output and minimum consumption ascertain that the pressure of
the gas used has the values indicated in the table of "burner characteristics".
The joint is mounted on the intake area of the pipe, fitted with a filleted nut G 1/
2", between the sealing components. Screw the parts without forcing, turn the
joint in the direction required and then tighten everything.
13
Installation
Advertisement
Table of Contents
