Introduction; Extractor Version; Filter Version - AEG 1300 D Operating And Installation Manual

Introduction

Extractor version

• The hood is supplied as an extractor unit and can also be used with
a filtering function by fitting one activated carbon filter (special
accessory).
• You will need original AEG activated carbon filter for this function
(see Special Accessories).
• The unit features two outlet holes, one of which A is located on the top
of the unit while the other B is located on the rear.
• To connect up the hose, you should first fit the bayonet-mounting
flange C (Ø 120 mm) on the outlet required (if using the top outlet, fix
the flange in place using the screw supplied as shown in Fig. 1).
Close off the unused hole using the bayonet fitting caps D.
Fig. 1
• Warning! If is decided to use the rear outlet hole B, first remove the
sponge E that closes that hole. Fig. 2.

Filter Version

• The air is filtered and recirculated
through the front grid.
• Move the lever G to position F - Fig.
3.
• You will need an original AEG
KF12/13 activated carbon filter
for the filtering function. (See
Special Accessories).
52
Fig. 2
Fig. 3